QN(4) Kernel Interfaces Manual (Amiga) QN(4)

NAME

qnEthernet driver for Fujitsu MB86950 based boards

SYNOPSIS

qn* at zbus0

DESCRIPTION

The qn interface provides access to the 10 Mb/s Ethernet network via the Fujitsu MB86950 Ethernet chip set.

Each of the host's network addresses is specified at boot time with an SIOCSIFADDR ioctl(2). The qn interface employs the address resolution protocol described in arp(4) to dynamically map between Internet and Ethernet addresses on the local network.

HARDWARE

The qn interface supports the following Zorro II expansion cards:
QuickNet
Resource Management Force's Ethernet card, manufacturer 2011, product 2

NOTES

Multicasting not done yet. If the driver happens to lock up, you may use ifconfig(8) to force the driver down and up again. This usually helps.

SEE ALSO

arp(4), inet(4), intro(4), ifconfig(8)

HISTORY

The qn interface first appeared in NetBSD 1.1
October 5, 1995 NetBSD 6.1